OneUp EDC Threadless Carrier

A Threadless, no tap install option that lets you store the EDC V2 Tool  inside your stem/steerer tube without threading your steerer tube. EDC Tool sold separately.

The Threadless Carrier replaces your star nut and lets you preload your headset with a bolt, while also creating a space for the EDC Tool.

Easy to install in less than 10 minutes. 

Compatible with EDC V2 Tool (You must use the small EDC V2 Storage Capsule with the Threadless Carrier.)  The tire plug and bacon strips fit within the small storage capsule.

Chain pliers are not compatible with the threadless carrier set up.

The EDC Threadless carrier does NOT support the CO2 cartridge carrier feature on the EDC Tool 

The EDC Threadless Carrier is NOT compatible with V1 EDC Tools (Green Multi-Tool)

 The EDC Threadless Carrier is Not compatible with the Large Storage Capsule

ENSURE YOUR FORK IS COMPATIBLE - VERY IMPORTANT

Incompatible forks: Fox E-Optimized Forks, Fox 38 Performance/Rhythm series Forks, Rock Shox 35 Forks, Rock Shox Judy Forks, Rock Shox eMTB Domain forks, Giant Overdrive 2 Forks. Cannondale Lefty Forks. Carbon Steerers

STEERER TUBE LENGTH  

Most forks are compatible, except for a small number of forks with very short steerer tubes. For the following cases your fork steerer tube length must meet the minimum length requirement.

• Fox Forks (excluding Fox 38 forks) = 190mm min
• Fox Factory/Perf. Elite 38 Forks = 245mm
• RockShox Forks  = 220mm min
• All other compatible forks = 190mm min

Measure from the underside of your fork crown to the top of your spacer stack, or top of your stem if you are not running any spacers above your stem.